![]() STS-RF1 mounting enclosure is a shielded chassis with detachable terminal block for mounting a single Stick-On module onto a flat surface. In addition the modules may be fitted in conjunction with RDL Flat-Pak and RDL Rack-Up modules in certain of the housings designed for these. A range of accessories are available for mounting modules. ST series modules are supplied with a self-adhesive foam pad which can be used to attach the module to a clean flat surface. Avoid mixed use! Input voltage 0-36VDC, output voltage typically 0.7VDC less than input. One ST-PD5U should be used per power rail employed, ie: one to feed single-rail devices, two to feed dual-rail devices. Typically it would be used to provide the supply voltage to five individual Stick-On modules from a single, possibly remote, source. This unit provides five individually de-coupled and diode isolated outputs from a single DC input. 2 Compressor limiter / gain control modules.Mastervolt Charge Mate Pro 40) is used to current-limit the alternator, but needs an intelligent additional control to terminate the charge of a lithium battery.Categories By brand New products Audio and data connectors Video and RF connectors Power connectors, distribution and batteries Connection panels and stageboxes Fibre optic cables, connectors and interfaces Cable assemblies, patchcords and leads Cables Cabling accessories and tools Bags and cases Racks and enclosures Rack accessories and hardware Lights, clocks, furniture, fittings and equipment supports Drives, memory, media, labelling and sound effects Microphones Radio Microphones Microphone supports, amplifiers, powering and accessories Headphones, headsets, earpieces, amplifiers and wireless systems Hearing protection and noise control Record, replay and radio receivers Audio interfacing Video interfacing, processing, monitoring and camera accessories Audio mixers and processing Amplification Loudspeakers and audio monitoring Test and measurement Communications, conferencing and datacoms Assistive Listening Index By brand Index New products Special offers Clearance list In addition, the Lithionics Battery® 12V ACR provides solutions for less common use cases where 2 nd alternator is installed to charge the house battery, but its internal regulator is not designed for fine charge control of lithium batteries, as well as cases where a 3 rd party battery disconnect (ex. At the same time, a lithium battery requires charge termination when fully charged, so our 12V ACR keeps it disconnected after the charge cycle is completed. Lithium batteries have an advantage of absorbing as much charge current as possible during the bulk charge stage, which could overheat and potentially damage stock engine alternators, so our intelligent 12V ACR reduces the duty cycle and allows cooling periods. Our intelligent 12V ACR allows customers to take advantage of all situations to keep both batteries charged, while keeping them separate when charging is not available or not desirable. Normally, when the engine is running, the chassis battery is charging, but when the vehicle is stationary and connected to the power grid, the house battery is charging. In a typical vehicle the chassis battery is reserved for engine starting, while the house battery is used for “hotel” (or house loads) or work-related loads. to allow charging separate Chassis and House batteries from common charge sources such as an engine alternator, inverter/charger, solar. An Automatic Combiner Relay (ACR) is often used in vehicle applications such as RVs, Work Trucks, Marine vessels, etc.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |